DIY Orchid Hanging Baskets

Stuff:
Four 5/8 x 5/8 x 36" wood rods, cut into 6" pieces
Some hanging loops
A ceiling hook
Some wood glue
Some water based wood sealent
A hammer
Some small nails

I started by laying out the first level of the basket.  On the bottom, I used 4 sticks across, hopefully enough to contain the orchid media.

For ease of building, aesthetics, and sturdiness, I decided to glue every contact point, and nail about half of them.  On the bottom, I nailed every piece.

Once the bottom was built, I just kept building upwards until it was the height I wanted

I didn't glue the top pieces, because I needed to put the loops in.  I scored the ends of the piece of wood with a rasp, and put on a generous amount of wood glue.  I didn't have a clamp, so I just put some books on it to hold it down while the glue dried.

I decided to seal it; I didn't want the wood to rot.

When the sealent dried, I screwed in the loops

Here's the basket with the orchid in it:

I still have to decided where to hang it and tie the twine to the loops and ceiling hook... but you get the idea

It's not perfect, I know, but it's my first time and I did it alone so I think I did ok.

Some problems I encountered were the rods splitting when I nailed them into place.  Next time I would be more careful about nailing a little further from the end.

Also, the rods weren't all perfectly 6"... there was sometimes a small .25" variance (at most).  I don't think I'll ever be sawing them perfectly, so instead of worrying about it, I just designated one side as being the "back" of the box, and any excess wood sticks out on that side.